Storage & Use
As with most sippy cups, ours are designed to be used with milk, water or juices that don’t contain pulp. Do not fill this cup with fizzy (carbonated) beverages, formula, or hot liquids.
It’s important that you inspect your cup before each use. Do not store or leave the cup in direct sunlight or near a source of heat, and don’t allow it to contact solvents or harsh chemicals.
This cup is…
- Not suitable for use in a conventional oven, a combination microwave oven, or any other heating device.
- Not suitable for microwave use apart from sterilising. See cleaning and sterilisation instructions for more information.
Instructions for cleaning your cup
Before first use, disassemble and thoroughly clean the cup. Place all components in boiling water for 5 minutes to ensure that they’re sterile. This step is not recommended for our Insulated Cups, these are suitable for sterilisation by cold water tablet/liquid solution only. All other cups are suitable for sterilisation by steam (electric and microwave), boiling or cold-water tablet/liquid solution.
All the parts of this cup can be washed in the dishwasher but be sure to place them on the top shelf only, and don’t use solvents or harsh chemicals. To avoid stains, do not allow the cup to contact oil-based foods or tomato-based sauces, and to prevent damage, avoid using a brush on the soft part of the valve.
Before every use clean the cup carefully, and always wash it immediately after use. To clean your cup…
1. Unscrew the lid and open the flip cap to expose the straw.
2. Remove the hard straw
3. Use your thumb to push out the hard valve from under the lid
4. Remove the silicone straw from under the lid.
5. Wash all parts thoroughly in warm soapy water and rinse in clean water.
Instructions for reassembling your cup
Always shake parts after washing to remove excess water and leave to air dry before re-assembling.
Your cup could leak or be difficult to drink from if not assembled correctly as follows…
6. Align the silicone straw and the hard valve, press together. Ensure part A of the soft side is fully pushed through the hole of the hard side. This is essential to make sure the valve functions correctly.
7. (a/b) Install the silicone straw with the hard valve from under the lid, pull the straw until it clicks. Push the hard valve firmly until the three prongs lock into place.
8. Reassemble the hard straw by pushing firmly into the hard valve.
9. Screw on lid.
